Alinco DR-B185HT Instruction Manual page 27

MHz SCAN
Scan frequencies that are below 1 MHz.
For example, for scanning 144 MHz, frequencies will be scanned
repeatedly from 144.000 MHz to 144.995 MHz in accordance with the
channel step.
1.
Press the key to enter VFO mode.
V/M
2. Press and hold the dial.
When scanning starts, the
1 MHz decimal point of the frequency
display will flash.
3. Use dial or [UP]/[DOWN] keys to change the direction. Press any
key (other than the [UP]/[DOWN] keys) to exit.
GROUP SCAN
Scan groups in memory mode or channel display mode.
Enough numbers of memory channel must be programmed in advance
to use this feature.
Only channels stored on memory channels will be scanned. Channels 0
to 499 will be scanned.
However, C, P1, P2, PR are exceptions.
Scanning starts from the selected memory channel number, and
channels will be divided into groups according to the group scan step
settings explained later in the set mode (menu 31).
• When the group scanning step is set to 10
50 groups (GROUP1: Channel 0 to 9, GROUP2: Channel 10 to 19, ...)
• When the group scanning step is set to 20
icon and
KEY OPERATIONS
25 groups (GROUP1: Channel 0 to 19, GROUP2: Channel 20 to 39, ...)
• When the group scanning step is set to 30
17 groups (GROUP1: Channel 0 to 29, GROUP2: Channel 30 to 59, ...,
GROUP17: Channel 480 to 499)
• When the group scanning step is set to 40
13 groups (GROUP1: Channel 0 to 39, GROUP2: Channel 40 to 79, ...,
GROUP13: Channel 480 to 499)
• When the group scanning step is set to 50
50 groups (GROUP1: Channel 0 to 49, GROUP2: Channel 50 to 99, ...)
1.
Press the key to enter memory mode. Or, turn off the power,
V/M
then turn on the power again while pressing the
channel display mode.
2.
Select a channel from groups within scanning range.
3. P r e s s a n d h o l d t h e d i a l t o s t a r t
scanning.
When scanning starts, the
flash.
Suppose you programmed 20 memories, set group step as 10,
select ch. 5 and start scanning, it scans between ch. 0 and ch. 9.
4.
Use dial or [UP]/[DOWN] keys to change the direction. Press any
key (other than the [UP]/ [DOWN] keys) to exit.
C,P1,P2 and PR are exceptions and can't perform the group
scanning. A beep sounds to alert.
6
key to enter
V/M
icon will
18