Dcs Scan - Alinco DR-B185HT Instruction Manual

6
KEY OPERATIONS
PRIORITY SCAN
Scan priority channels every 5 seconds in VFO mode or on the normal
display of memory mode.
Priority scan is always executed in the background when the priority
scan setting is set to ON at the Menu 29 in the Set mode setting.
appears while Pri function is activated.
When a priority channel receives a signal, the
currently selected frequency or channel will be
switched to the priority channel and the
icon will flash.
Even if the frequency or channel selected before being switched has
a reception channel, the signal received by the priority channel will be
prioritized.
Tone Scan
19
This function automatically searches for the CTCSS tone an incoming
signal might carry. This feature is useful to search the encoding tone of a
repeater, or to communicate with a station operating in TSQ (CTCSS
squelch) mode.
1.
Press the key until entering to the
TS/DCS
CTCSS decode setting mode.
The and icons will light up.
2.
Press and hold [UP]/[DOWN] keys for a second until the 2nd beep
is heard then release it immediately to start scanning. It scans
39 tones in order. Use [UP]/[DOWN] key to change the scanning
direction.
The icon will flash, and it stops when
the matching tone is detected.
3. The scan won't resume until the operation is repeated.
4.
Press any key (other than [UP]/[DOWN] keys) to exit.
MEMORY Scan(channel scan)
Scans all memory channels unless Memory skip feature is selected for a
icon
given memory.
1.
Press the
V/M
will light up and the transceiver will enter memory mode.
2. Press and hold [UP]/[DOWN] keys for
a second until the 2nd beep is heard
then release it immediately to start
scanning.
3. Use dial or [UP]/[DOWN] keys to change the direction. Press any
key (other than the [UP]/[DOWN] keys) to exit.
Memory channels should be programmed in advance to operate
memory scanning.
„ „

DCS SCAN

This function automatically searches for the DCS tone an incoming
signal might carry. This feature is useful to search the encoding tone of a
repeater, or to communicate with a station operating in DCS mode.
1.
Press the
TS/DCS
The icon will light up.
2. Press and hold [UP]/[DOWN] keys for a second until the 2nd beep
is heard then release it immediately to start scanning. It scans
104 tones in order. Use [UP]/[DOWN] key to change the scanning
direction.
key to select memory mode.
key until entering DCS decode setting mode.