13. Loading Bottom Supply shaft
1. Remove bottom supply shaft and slide the new roll on
a. Position the supply roll using the same number position used on the top
supply roll in section #11B to align the top and bottom rolls.
When using printed media, position one Media Alignment Disk on
i.
each side of the roll to keep edges lined up
Media rolls can be very slippery and 'telescope' when loading on
ii.
the supply shaft and running (see picture below).
2. Adjust the brake tension by turning the adjusting sleeve
(see Adjusting Roller tensions section 14)
Bottom supply shaft
Gfp 300 Series
Bottom supply shaft with Media Alignment Disks
NOTE: Printed media can be very slippery and 'telescope' when
loading on the supply shaft. Use the alignment disks to keep the
edges properly lined up.
17
June 2023
Cardboard liner rewind