Table of Contents
Advertisement
10. Additional Installation items
1.
Plug foot pedal into rear panel near power cord
2.
Check drive chains for tightness
3.
Check all drive set screws for tightness
4.
Check all electrical connections and input power and test for proper operation
11. Loading Bottom media or Kraft paper roll
1. Loosen the fastening screws on the brake assembly on one side of the supply
shaft, and slide brake assembly off the supply shaft.
2. Slide the new roll onto the supply shaft
3. Return the brake assembly to the supply shaft
4. Position the supply roll in the middle of the supply shaft and measure the
distance from one side of the roll to the side frame
measurement when loading the top supply roll in section #13 to align the top
and bottom rolls)
5. Fasten the screws for brake assembly (Note: there should be 1/8" clearance
between the positioning and the adjusting sleeves of the film core adaptor to
make brake adjustment easier)
6. Adjust the brake tension by turning the adjusting sleeve
(Note: the brake tension should not prevent roll from turning)
1. Supply shaft 2. Substrate 3.Film Core 4. Positioning sleeve
5. Brake adjustment screw 6.Fastening screws for the brake assembly 7. Brake assembly
Gfp 230 C
14
June 2012
(You'll use this
Advertisement
Table of Contents
