Speed; Temperature; Gap; Pressure - Gfp 663TH Operation Manual

GAP

: When pressed, raises the top roller all the way to the top opening.
GAP : When pressed, raises the top roller incrementally.
PRESS: Takes you to the Operational Pressure screen where you can select preset pressures
or input any desired pressure by using the +/- keys or using the Finger Slide.
PRESS : When pressed, lowers the top roller incrementally.
PRESS : When pressed, lowers the top roller all the way to the closed position.
WARNING: When flashing, alerts the operator to unsafe or out of parameter conditions.
When pressed, takes you to the screen identifying the condition(s) for correction.
TOP TENSION: Allows the operator to input desired over/under tension warnings for the
product being run.
BOTTOM TENSION: Allows the operator to input desired over/under tension warnings for
the product being run.
SERVICE: Takes you to the Service screens. Inside these screens, operators can make
changes to factory parameter settings for the following operations:
Gap

Pressure

Top Tension

Bottom Tension

Temperature

Speed

RESET
COUNTER: The operator can input starting lengths . It allows the operator to see total film
usage for the job just run as well as daily and overall usage.
PRINT: Imports the length of film used in the current job. The operator can create and store
types of film and then choose any of the different types of film to printed on the label. This
screen also allows the operator to input the Month, Day Year as well as the time of day.
RUN/FOOT: Allows the operator to choose between running continuously or using the foot
pedal.
FWD/REV: Allows the laminator to run in either forward or reverse mode. Reverse only
runs with the foot pedal.
HOT/COLD: Allows the operator to choose between no heat or top heat assist.
Gfp 663TH
(8Dii)
(8Diii)
(8Div)
(8Dv)
(8Dvi)
(8Dvii)
(8Dviii)
April 2021
14