Entering The Programming Mode - Eaglemaster E8 User Manual

7. If PIN code correct insert , the siren will give 1 long chirp to acknowledging that the
system is ready for programming of new PIN code, see next step #9.
If PIN code incorrect insert, the system will exit the mode by given 2-long chirp.
<< Suppose that you want set new PIN code is 3.8 >>
8. To programme the 1st PIN code by press the Valet button the number of times
corresponding to the 1st digit of your PIN code. Press 3 times of the Valet button,
(each time the Valet button is pressing, the status LED will activated) .
9. Press the remote button 1 once, siren will give 1 chirp to confirm the 1st digit code .
10. To programme the 2nd PIN code by press the Valet button the number of times
corresponding to the 2nd digit of your PIN code. Press 8 times of the Valet button,
(each time the Valet button is pressing, the status LED will activated) .
11. Press the remote button 1 once, siren will give 2 chirp to confirm the 2nd digit code .
12. Wait a second, the status LED will notify the 2 digit PIN code, by 3 flashes - pause - 8
flashes.
13. If you wish to change the new PIN code again, press and hols the Valet button until
transceiver give 1 long beep, to indicate that you can programme again from above
step 9 .
14. To Exit the mode, turn ignition to ON , and you will hear two long siren chirps.
You must write down or remember your PIN code.
Note:
Please notice that the time between your actions shall be less than 20 sec; otherwise the
system will automatically exit the programming mode and you will hear two long siren chirps.

Entering the programming mode

1. Disarm the system .
2. Turn the ignition from on to off.
3. Within 10 sec after switching off the ignition press and hold the Valet button over 3 sec ,
the LED starts flashing , release the Valet button.
4. Press and hold the Valet button, you will hear siren chirp
(from 1-short
5. While give 1-long chirp , release the Valet button to programme Table-1.
While give 1-long+1short chirp , release the Valet button to programme Table-2.
While give 1-long +2short chirp , release the Valet button to programme Table-3.
6. After release the Valet button, you will automatically at the programming mode for the
No.1 function. The LED starts flashing as separate flashes and the lights will turn ON.
The number of the LED flashes in the programming mode for a certain function
Corresponds to the programmed function number;
7. - Change the status of the function by press the button 1.2. 3.4 of the transmitter. You will
hear 1, 2, 3,4 siren chirps depending on the new status of the function,
- Switch into the next function by press the Valet button one time.
- Exit the programming mode (e.g. turn on the ignition).
Note
Please notice that the time between your actions shall be less than 20 sec; otherwise the
system will automatically exit the programming mode and you will hear two long siren chirps.
2-short 3-short 1-long 1-long+1-short 1-long+2shot ),