Anti-Hi-Jack Mode - Eaglemaster E8 User Manual

This feature will protect your vehicle in the event that there is an attempt to Hi-jack the
vehicle. The system allows using three independent or simultaneous options to turn on the
function Anti-Hi-Jack.
If the system turned on Anti-hI-Jack mode, the parking lights will flash 1 time and the LED
will start flashing fast indicate that the mode is turned on.
- Standby door switch activates:
To operate it when driving the car, press button
one chirp and LED start flashing twice per second, system now is in standby Anti car-
jacking mode. Under this standby mode, if a door is forced been open and close, the system
will activate Anti-HI- jack mode immediately. The parking lights will flash once and the LED
will fast flash to show the system is enter anti car-jack mode.
EXIT: Under standby mode, you may exit this mode, if it is not activate the door, press
button
- Remote Anti-Hi-Jack:
1. Turn on the ignition or start the engine.
2. Simultaneously press the buttons 1+3
,1 flash of parking lights and the status LED start flashing.
- Ignition turn Anti-Hi-Jack:
If programmed with the feature, each time ignition switch has been turn ON , the system will
auto enter anti-hi-jack mode. The parking lights will flash once and the status LED will start
flashing to show the system is enter anti car-jack mode.
- Door switch Anti-Hi-Jack:
If programmed, to operate it when driving the car, if a door is forced been open and close,
the system will activate Anti-car jack immediately. The parking lights will flash once and the
LED will fast flash to show the system is enter anti car-jack mode.
2-way LCD display :

Anti-Hi-Jack mode

for over 2 seconds, siren will give two chirps and LED off.
(Table-1 of NO.5 remote status).
for over 2seconds, siren will give
until the acknowledgement signal
(Table-1 of NO.5 ignition status).
(Table-1 of NO.5 Door switch status).
The AHJ icon will turn on
after 60sec. of active the
mode.