Valet Mode - Eaglemaster E8 User Manual

- Remote Zone2 sensor bypass:
This system offer 2 stage sensors bypass feature . Within 5sec. after set arming, to press
button once , the system will give 2 short chirps , the 1st stage bypassed. Press button
Once again, within 5sec. the system will give 3 short chirps, the 2nd stage bypassed.
2-way LCD display :
Note: - if remote sensor bypassed, it will be detected again by next arming.
- if armed with silent mode, to operate sensor bypass will only indicate by lights flash.
I f you are going to have your vehicle serviced, parked by a valet or washed you will want to
put your security system Into valet mode. To enter valet mode as follows:
With Valet button:
1. Disarm the system .
2. Turn the ignition from on to off.
3. Within 10 sec after switching off the ignition press and hold the Valet button over 3 sec ,
the LED starts flashing , release the Valet button.
4. Press and hold the Valet button, you will hear siren chirp (from 1 to 3 chirp sound), while
give 1 chirp sound, immediately release the Valet button. You will automatically at Valet
mode, the LED steady ON .
With remote:
1. Turn the ignition to ON status.
2. Press the button
2-way LCD display:
When the system is in the valet mode it can not be armed. The door lock and unlock will
function as keyless entry system.
To exit valet mode:
Turn Ignition switch to ON position , then press button
will hear siren provide 2 long and LED light OFF to confirm exit this mode and in alarm mode.
The 2-Way remote will respond 1 long and 2 short beeps.
Press the button
Zone2- 1st stage
sensor bypass.
With 2 beeps sound

Valet mode

for over 2sec. until the status LED steady ON.
within 5sec. of amring.
Zone2- 2nd stage
sensor bypass.
With 3 beeps sound
Note:
Under Valet mode, each time
turn Acc off , the siren will give
2 chirps for notification.
for over 2seconds. You