Check-In Range Notification (On/Off ); Time Adjust Mode - Eaglemaster E8 User Manual

Check-in range notification (on/off )

Arming the system within 2 seconds, press button
system will enable this Check- in range function.
The 2way remote
will respond:
- With in 5 minutes, the 2-way remote will than give 1 beep sound every one minute for 5
cycles to remind the user within range.
- After 5 minutes, the 2-way remote will detect range every 10 minutes and without any beep
sound, the icon
For friendly usage, the 2-way remote will provide 2 beeps/ 3cycles and flashing icon
if the user is out of the receiving rage. However, afterwards if the 2-way remote detect the
signal again from the system, the icon
range.
Note: If under Check-in range mode, if alarm triggered, this function will automatically
turn off (disable).

Time adjust mode

Besides operating for alarm functions, LCD remote control additionally provides 24-hour
real time clock.
Instructions:
1. Press and hold Button
2. Press button
24-hour display
3. Press button
The button may be held down to scroll faster.
4. Press button
Note: The remote will revert to normal operation from the set mode when 10-seconds has
elapsed without a button entry.
will constant on if the user within range.
for 2sec. to enter time-setup mode, 1 beep will be heard.
to select Hour & Min adjust setting. Icon flashing to indicate.
to turn up the numbers. Press button
to exit the setting mode. 2 beep will be heard.
once on the 2way remote , the
This Icon will turn on and give 1 beep
sound to indicate the function has been
turned ON.
will be ON to indicate the 2-way remote is within
Minutes display
to turn down the numbers.