Multi-Touch Gestures; Initial Set Up Procedures - Lighthouse Raymarine gS95 Installation And Operation Instruction Manual

6.9 Multi-Touch gestures

Raymarine a Series and gS Series multifunction
displays support multi-touch.
Multi-touch means that the display is capable of
recognizing multiple simultaneous touch inputs.
This means that you can use 2 or more fingers on
the screen at the same time to perform multi-touch
gestures.
Pinch to Zoom
The pinch to zoom gestures can be performed on
multifunction displays that support multi-touch.
Pinch to zoom consists of 2 actions:
• Move 2 fingers apart to zoom in.
• Move 2 fingers together to zoom out.
Pinch to Zoom can be used in the following
applications:
• Chart application.
• Weather application.
94

6.10 Initial set up procedures

Once your display has been installed and
commissioned, Raymarine recommends that you
perform an initial set up procedure.
Startup wizard
When you power-up the display for the first time or
after a system reset a Startup Wizard is displayed.
The wizard guides you through the following basic
configuration settings:
1. Language
2. Boat type
3. Configure Units (Units of measure)
4. Boat Details
• Minimum Safe Depth
• Number of engines
• Total fuel capacity (TFC)
• Number of fuel tanks
• Number of batteries
Note: These settings can also be set at any time
using the menus accessible from Homescreen
> Customize.
D12920-2
Additional settings
In addition to the settings covered by the Wizard,
it is also recommended that the following initial set
up tasks are completed:
• Set your date and time preferences.
• Adjust the display brightness (and set up a shared
brightness scheme if appropriate).
• Designate the data master.
• Select the GPS data source.
• Familiarize yourself with the product using
Simulator Mode.
Adjusting the display brightness
gS Series