Hd-Sdi Connection (Gs195) - Lighthouse Raymarine gS95 Installation And Operation Instruction Manual

4.24 HD-SDI connection (gS195)

The gS195 includes a High Definition Serial Digital
Interface (HD-SDI), which can be used to view a
compatible video source using the multifunction
display's Camera application.
1
1. HD-SDI camera
2. HD-SDI input data cable
3. gS195 multifunction display
Note: If your camera or external display do not
have a standard BNC connection then a third party
adaptor and / or converter may be required.
The HD-SDI interface connections use BNC
connectors. It is recommended that Belden
1694A cable (not supplied) and the supplied BNC
connectors should be used to create the data
cables required for connecting the camera to the
multifunction display.
HD-SDI camera connection
The supplied BNC connectors and boot kit should
be used when connecting a camera using the units
HD-SDI interface.
When making the data cables the cable should be
fed through the boot first before attaching the BNC
connector to the end of the cable. It may be possible
to push the boot over the BNC connector and onto
the cable, however care must be taken not to split
the protective boot.
HD-SDI connection
1. 75 ohm BNC connector (Supplied)
2. Boot (Supplied)
3. Data cable (not supplied)
68
2
1 2
Connecting the data cable
Follow the steps below to connect your HD-SDI data
cable to the multifunction display.
1
3
D13045-2
1. Ensure the BNC connector is correctly orientated.
2. Fully insert the BNC connector into the relevant
HD-SDI connection on the back of your
multifunction display and turn the locking collar
clockwise until locked into position.
3. Push the protective boot over the BNC connector
and HD-SDI connection on the back of the
display.
4. Use 2 cable ties (supplied) to secure the
protective boot over the connection.
Protecting disconnected cables
If a BNC cable is to be left disconnected then the
protective cap should be secured to the end of the
boot.
1
1. Disconnected the BNC cable from the
multifunction display.
2. Push the boot over the cap as shown below.
3. It is recommended that a cable tie be used to
secure the boot to the cap.
HD-SDI maximum cable length
The maximum recommended cable length is shown
below.
HD-SDI input cable
3
D13046-3
2
4
2 3
50 m (164 ft.)
D13048-3
D13050-1
gS Series