Selecting Datapages; Data Application Features - Lighthouse Raymarine gS95 Installation And Operation Instruction Manual

20.3

Selecting datapages

To select datapages using a non-touch multifunction
display follow the steps below.
From the data application:
1. Move the Joystick Down to goto the next page,
or
2. Move the Joystick Up to goto the previous page.
Data application

20.4 Data application features

The following features are available in the Data
application.
Change the order datapages
appear
Customize datapage content
Add new custom datapages
Rename the datapages
Delete datapages
Set boat details such as
number of engines, fuel
tanks, and batteries
Set the maximum RPM and
Red zone range
Change the units of
measurement
Adjust wind data response
times
Reset minimum and
maximum data readings
Reset all datapages to
defaults
Note: Relevant data must be available to your
multifunction display.
Changing the order of datapages
From the Customize menu: Menu > Customize.
1. Select Edit Page.
2. Select Move Page Up or Move Page Down.
Each time Move Page Up or Move Page Down
is selected the datapage will be moved 1 space
in that direction.
Customizing datapage content using
touch
On touchscreen multifunction displays you can
customize a data item by pressing and holding on
the item onscreen.
From the Data application:
1. Display the datapage that contains the data item
you want to change.
2. Touch and hold your finger on the data item.
After approximately 3 seconds the data item is
highlighted and the Select Data Category menu
is displayed.
3. Navigate the menu to locate the data item you
want to use.
• Changing the order of
datapages
• Customizing
datapage content using
touch
• Customizing datapage
content
• Adding a new datapage
• Renaming a datapage
• Deleting a datapage
• 20.7 Setting boat details
from the Data application
• 20.8 Setting engine RPM
range and red zone
• Changing units of measure
from the Data application
• 20.13 Setting wind
damping from the Data
application
• 20.11 Resetting minimum
and maximum readings
• 20.12 Resetting all
datapages
283