Enabling Ais; Displaying Ais Vectors - Lighthouse Raymarine gS95 Installation And Operation Instruction Manual

16.4 Enabling AIS

Enabling AIS in the Chart application
To enable the AIS overlay in the Chart application
follow the steps below.
To enable the AIS overlay your system must include
an AIS receiver or transceiver. The AIS overlay is
not available in 3D view.
From the Chart application menu:
1. Select Presentation.
2. Select Overlays.
3. Select AIS: so that On is selected.
Selecting AIS: switches the AIS between On and
Off.
For AIS information refer to
Enabling AIS in the radar application
From the radar application:
1. Select Menu.
2. Select Targets.
3. Select Display AIS Targets.
4. Select the relevant option from the list.
From the Display AIS Targets menu you can
switch on All AIS targets, only Dangerous AIS
targets or switch AIS targets Off.
188
Chapter 16 AIS function.

16.5 Displaying AIS vectors

You must have the correct data available before AIS
vectors can be displayed.
A target is defined as active when it has the following
data displayed graphically:
• A COG/SOG vector indicating the predicted
distance that a target will travel within a given
period of time.
• A heading and direction of turn indicator.
Enabling and disabling AIS vectors
From the chart or radar application:
1. Select an AIS target.
The AIS target context menu is displayed.
2. Select AIS Vector.
Selecting AIS Vector will switch between On and
Off.
Note: The same target vector and safe zone
settings apply to both radar MARPA and AIS
targets.
gS Series