Table of Contents
Advertisement
5.3
Select & Go
Select & Go is a rapid method of setting up a job without the need for full programming. You
as the user decide which hoppers to load - the machine's software then automatically cre-
ates a simplified programme. First select the fold type and press
press
again. This takes you to the Run screen - press the Start button to calibrate the
machine and begin running. See section 5.4 on the following page for details of cali-
brating the machine.
Points to note:
1.
You must load each hopper with the default size form set for that hopper (see
Supervisor menu on page 30 for details on setting defaults).
2.
For folded documents, the fold type will be the default setting for that hopper.
3.
The prime (address) document must be in the hopper furthest from the insert
head, eg. if the lower and middle hoppers are loaded on a tower folder module,
the prime document must be the middle hopper. The prime document must be
loaded address side down and leading for all fold types.
4.
There is no OMR or Barcode facility for Select & Go - for this, full programming
by authorised personnel must be used.
14
. Load the hoppers and
Advertisement
Table of Contents
