Table of Contents
Advertisement
5.5.3 advanced settings
Advanced settings allow adjustments to be made to various machine functions. It is
specific only to the job you are in when you make changes, and will be saved with the job,
even when the machine is switched off. Note that this function is password protected.
Warning: Changes made in this function may adversely affect the machine. Use it
only if you know what you are doing!
Collate Pocket adj.
fingers adj.
Start Speed
Seal Time
adjust wetter
adjust wetter
start
adjust env seal
stop
adjust env stop
pos
Insert in env pos.
adjust env rev
pos
Adjusts the width of the insert head collate pocket. In steps of
0.1mm.
Adjusts the width of the insert fingers. In steps of 0.1mm.
Speed at calibration and first running. Default = 1.
Adjusts time that the filled envelope is held in the closer for
sealing. Note that increasing will slow the machine. In steps of
milliseconds.
Adjusts the point at which the wetter beam drops to wet the
flap (+ve = more wetting). In steps of 1mm.
Adjustment of the point at which the wetter beam lifts (+ve =
more flap length is wetted). In steps of 1mm.
Adjusts how far into the closer rollers the envelope is fed (+ve
= more infeed). In steps of 1mm.
Adjusts the envelope stop position at insert (+ve = further for-
ward). In steps of 1mm.
Adjusts the amount of insertion of the insert pack into the enve-
lopes (+ve = further in to envelope). In steps of 1mm.
Adjustment of the amount of envelope foward travel after flap
wetting, before reversing to enter the sealing rollers. +ve = fur-
ther forward into the output rollers, towards the exit direction.
19
Advertisement
Table of Contents
