Table of Contents
Advertisement
doubles det.
deskew
Select Hopper
Save as Temp.
Note: If you wish these settings to be default, see 'Supervisor Mode' on page 30.
When all options for #2 have been set, select 'Done'. Depending upon your settings, further
choices may now need to be made, as decribed below.
Mark reading:
If this was set to OMR or Barcode, the appropriate settings screen will then be displayed.
See page 27 for details of OMR setting, page 29 for Barcode settings.
Select Hopper:
If this was selected, the following screen will be displayed, allowing you to choose which
hopper this item is to be fed from, instead of using machine default. Note that the selected
hopper will be highlighted in the graphic. Select 'Done' when finished to return to the edit
screen.
Save as
template:
24
Detects for double documents. On by default. Deselect only if you are
using unusual stationery that may cause spurious errors (eg. some
sheets heavy, dark text and some almost none).
Straightens a document if it is skewed. Options are Off/ Low / Me-
dium / High. If deskew is selected, note that the operating speed is
slowed; a setting of 'High' will slow the machine more than 'Low'.
You can decide where on the machine this hopper will be located. If
selected, you will move to further settings (see below) when you have
finished in the above screen.
Saves these settings as a template. If selected, you will move to fur-
ther settings (described later) when you have finished in this screen.
If this was selected, the following screen will be displayed, allowing
you to save the edited item as a template for future items. Up to four
templates can be defined, and when all are used, you must replace
an existing template to save the new one.
Advertisement
Table of Contents
