Table of Contents
Advertisement
5.5.2 Count
The 'Count' function allows the global or job counts shown on the display to be set to zero.
The global count continues to accrue even if you switch to another job; the job count applies
only to the job you are running. To zero either count, stop the job you are running by press-
ing the Stop button. This will display the status screen in 'Ready' mode, as shown below.
Job count
Batch count
(where ap-
plicable)
Now press x and a list of options will be shown. Select 'Global Count' or 'Job Count', and you
will enter the count reset screen:
If you are sure you want to zero the count, press
shown above. Note that the machine's internal count is not reset. This count can be seen in
Supervisor mode (see page 30).
Note: If you zero either either global or job count, this does not affect the batch
count. This will reset at the end of each batch.
18
. This will reset the appropriate count
Running count
Running output
rate
Advertisement
Table of Contents
