Headlamp Bulb Replacement - Victory 2009 VISION Rider's Manual

visionownersmanual.book Page 195 Wednesday, February 13, 2008 4:31 PM

Headlamp Bulb Replacement

To replace a headlamp bulb:
1. Remove air filter (page 143). Pull sealing boot
away from the back of the bulb(s) and housing.
2. Press the looped end of the wire clip bulb retainer
and swing the end toward the center of the bulb to
release it from the latch tab.
3. Pull bulb out with wire connector attached.
4. Disconnect wire harness. Install new bulb. DO
NOT TOUCH glass portion of headlamp bulb. Oil
on the glass surface of bulb could cause bulb
failure. Clean with denatured alcohol if touched.
5. Install bulb by reversing steps. Be sure boot is
sealed tightly around bulb base and lens to
prevent moisture from forming inside the lamp.
MAINTENANCE
Headlamp
Bulb Access
195