visionownersmanual.book Page 152 Wednesday, February 13, 2008 4:31 PM
MAINTENANCE
Drive Belt / Rear Wheel Alignment
1. Look at the alignment reference marks (3) on
each side of the swingarm and the marks (4) on
the axle plates to verify proper wheel alignment.
Axle plate mark to reference mark alignment
must be the same on both sides.
2. If the marks are not aligned, perform all steps of
the Belt Tension Adjustment procedure
(page 151).
3. Before and after tightening the axle nut, verify
belt tension and wheel alignment are both
correct.
152
3
4