visionownersmanual.book Page 111 Wednesday, February 13, 2008 4:31 PM
Priming the Fuel System
If the motorcycle has run completely out of fuel, prime
the system before starting the engine.
1. Fill the fuel tank.
2. Turn the ignition key ON.
3. Turn the engine stop switch to the RUN position (the
fuel pump will run momentarily).
4. Wait for the pump to stop running (about 3 seconds).
5. Turn the engine stop switch to STOP and wait 10
seconds.
6. Repeat steps 3-5 four or five times to thoroughly
prime the fuel system.
7. Turn ignition key OFF.
8. Start the engine following normal procedures.
OPERATION
111