Victory 2009 VISION Rider's Manual page 197

visionownersmanual.book Page 194 Wednesday, February 13, 2008 4:31 PM
MAINTENANCE
Street Trim Panel Installation
Trim Panel Installation
1. Remove license plate bracket (page 191) and
trunk (if equipped).
2. Lift edges of tail molding in the order outlined on
page 193 for Street Trim Panel Removal.
NOTE:
Lift tail molding enough to provide clearance to
install the seat trim panel. It is not necessary to
remove the tail molding.
3. Set the trim panel in place and push straight
down evenly until all four tabs are seated in the
slots.
4. Align tail molding and snap it back into place,
pressing each tab in order shown.
5. Install the seat (page 190) and license bracket.
194
3
36 LB-IN.
(4 nM)
2
1