Valor Legend 736XN Installer's & Owner's Manual page 2

WARNING: Do not operate the appliance with the
glass front removed, cracked or broken.
Replacement of the glass should be done by a
licensed or qualified service person.
(The front frame and glass window may be
temporarily removed by the owner for cleaning the
interior of the firebox, etc. The frame and window
must be put back prior to operating the appliance.)
i. Only the authorized Valor replacement window
unit listed in the repair parts booklet must be fitted -
never use substitutes.
If the glass is damaged search inside and adjacent
to the appliance for any glass fragments.
Due to high temperatures, the appliance should be
located out of traffic and away from furniture and
draperies.
Children and adults should be alerted to the hazards
of high surface temperatures and should stay away
to avoid burns or clothing ignition.
Young children should be carefully supervised when
they are in the same room as the appliance.
Clothing or other flammable material should not be
placed on or near the appliance.
This appliance must be installed and repaired by a
qualified service person. The appliance should be
inspected before use and at least annually by a
professional service person. More frequent cleaning
may be required due to excessive lint from
carpeting, bedding material, etc. It is imperative that
control compartments, burners and circulating air
passageways of the appliance are kept clean.This
appliance should be installed and repaired by a
qualified service person.
Keep curtains, clothing, furniture and other
flammable materials at least 36ins (90cm) from the
front and top of the appliance.
Keep the appliance area well clear and free from
combustible materials, gasoline and other
flammable vapors and liquids.
When operating your new furnace for the first time, some vapors may be released which may cause a slight odor and could possibly
set off any smoke detection alarms in the immediate vicinity. These vapors are quite normal on new appliances. They are totally
harmless and will disappear after a few hours use.
CAUTION
Never attempt to burn paper or any other material in
the appliance.
Keep the area in front of the bottom grill clear to
prevent obstruction of air flow to the appliance for
combustion.
This appliance requires a source of fresh air in order
to vent properly. The venting system should be
checked periodically.
Recent trends in home improvement and new tighter
construction techniques have contributed to
problems with venting. If you suspect that your
appliance is not venting correctly, do not operate –
seek expert advice.
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of
the control system and any gas control which has
been under water.
If any changes are made to the room construction in
the vicinity of the appliance after installation (e.g.
additional mantle etc.) make sure that the changes
conform to the installation requirements in this
manual.
When equipped with the optional circulating fan kit
(Part #710CFK) or power vent kit (Part #720PVC), the
appliance must be installed and electrically
grounded in accordance with local codes or, in the
absence of local codes, with the latest edition of the
National Electrical Code ANSI/NFPA 70 (in USA) or
CSA C22-1 Canadian Electrical Code.
This appliance must be properly connected to a
venting system. It is equipped with a vent safety
shutoff system. Operating when not connected to a
properly installed and maintained venting system or
tampering with the shutoff system can result in
carbon monoxide (CO) poisoning and possible
death.
NOTE
2