Table of Contents
Advertisement
1. Disconnect the battery negative (–)
terminal.
2. Unlock and remove the engine
cover (see page 39).
6 × 22 mm
FLANGE BOLT
PLUG MAINTENANCE COVER
3. Remove the 6 × 22 mm flange bolt
and remove the plug maintenance
cover.
LOCK TAB
IGNITION COIL
WIRE CONNECTOR
4. Disconnect the wire connector
from the ignition coil by pushing
on the lock tab and pulling on the
connector. Pull on the plastic
connector, not the wires.
5. Use a 10 mm wrench to remove the
bolt holding the ignition coil.
Remove the ignition coil by pulling
it up slightly. Take care not give an
impact or drop the ignition coil.
Replace the ignition coil if drop it.
MAINTENANCE
BOLT
6. Use the spark plug wrench and 19
mm eye wrench to remove the
spark plugs.
7. Visually inspect the spark plugs.
Discard the spark plugs if there is
apparent wear, or if the insulators
are cracked or chipped.
SPARK PLUG
WRENCH
19 mm EYE
WRENCH
87
Advertisement
Table of Contents
