Table of Contents
Advertisement
6.3 Cutting Plotter/Computer Communication Problems
The messages shown below present problems in relation to cutting plotter/computer
communication.
Communication Error
Setup: MISC. key
Note:
The computer also needs to set up compatible communication parame-
ters to the cutting plotter set up.
HP-GL/2 Cmd. Error
If your cutting plotter does not recognize the HP-GL/2 or
HP-GL commands, please make sure the HP-GL/2 or HP-GL
commands applied to your cutting plotter are used
properly.
2614 Texoma Drive Denison, TX 75020 • 980 Contract St. Suite 110 Lexington, KY
Phone: 903-462-7700 or toll free 800-899-5655 • Fax: 800-966-6834
40
User Manual
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the enduraCUT 2 and is the answer not in the manual?