Operational Problems - SignWarehouse.com enduraCUT 2 User Manual

Pro desktop cutter
Table of Contents

Advertisement

6.2 Operational Problems

Some problems are caused by mechanical failure or failure of a specific operation during
plotting. In such cases, an error message will be displayed on the LCM stating the problem
and suggesting a solution. If the problem still exists after you have performed the recom-
mended solutions, have your cutting plotter serviced.
Error, Check Media
Or Drum or X Motor
Error, Check Media
Or Y Motor
Check Carriage
Sensor or VC Motor
Graph Was Clipped.
Data In Buffer
This message indicates that there might be a problem on
the X axis. Check if the drum is working well and if the
media is well loaded. Correct the problem and re-power
on to reboot system.
This message indicates that there might be an obstruction
to carriage relating to a problem on the Y axis. Correct the
problem and re-power on to reboot system.
This message indicates that the blade up/down sensor mal-
function. Re-power on to re-boot system. If the problem
still exists, contact SignWarehouse Technical Support.
This message indicates that the cutting exceeds the cutting
limit. Reload larger media or re-scale the plot to a smaller
size; then press the key followed by the display of LCM to
continue.
2614 Texoma Drive Denison, TX 75020 • 980 Contract St. Suite 110 Lexington, KY
Phone: 903-462-7700 or toll free 800-899-5655 • Fax: 800-966-6834
39
User Manual

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the enduraCUT 2 and is the answer not in the manual?

Table of Contents