Table of Contents
Advertisement
USB Driver Installation Cont'd
Connecting the plotter
1. Turn on the machine.
2. Connect the USB connector to the machine and then USB driver will installed
automatically. It will take a few minutes to find the device. Please DO NOT disconnect
the USB cable until the installation has completed.
3. You can double click the USB icon on the taskbar to make sure the USB device is
detected (Fig 2-13).
2.6 LXI Cloud Software Installation
Before you can proceed using your cutter, you need to install LXi software that you pur-
chased with the EnduraCUT 2. You'll find complete step-by-step instructions on our Tech
support Blog.
Please click here
http://www.signwarehouse.com/blog-support/getting-started-with-cloud-2/
to access the setup tutorial (Fig 2-13a) or surf to
2614 Texoma Drive Denison, TX 75020 • 980 Contract St. Suite 110 Lexington, KY
Phone: 903-462-7700 or toll free 800-899-5655 • Fax: 800-966-6834
15
User Manual
Figure 2-13
Figure 2-13a
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the enduraCUT 2 and is the answer not in the manual?
Questions and answers