Table of Contents
Advertisement
User Manual
6: If the plotter did not respond to the test cut (or if some other device was activated, you
must change the port setting to the correct one for the plotter (or connect the plotter to a
different USB port).
To change the USB port setting, right-click on "enduraCUT2S _USB_Printer_1" (just above
"EnduraCUT2S". From the pop-up menu, select Change Port (Fig 2-20). Then, from the menu
of available ports, select a different USB printer port (Fig 2-21). Repeat the Test Cut process,
making sure that the cutter is turned on and online. Once you have sucessfully performed a
Test Cut, you are ready to use your cutter to create vinyl graphics.
Figure 2-20
Figure 2-21
2614 Texoma Drive Denison, TX 75020 • 980 Contract St. Suite 110 Lexington, KY
Phone: 903-462-7700 or toll free 800-899-5655 • Fax: 800-966-6834
18
Hide quick links:
Advertisement
Table of Contents
