SignWarehouse.com enduraCUT 2 User Manual page 31

Position the pinch rollers in alignement with the white markers on the upper rail.
Push the lever downward to lower down the pinch rollers.
Turn on the power; the machine will be initialized. Then follow the instruction of LCM
to measure the size of the media.
Note:
Move the pinch roller by applying force at the
rear portion of the pinch roller support. Do not
move it by holding its front rubber roller (Fig 4.3).
Figure 4-2
2614 Texoma Drive Denison, TX 75020 • 980 Contract St. Suite 110 Lexington, KY
Phone: 903-462-7700 or toll free 800-899-5655 • Fax: 800-966-6834
31
User Manual
Figure 4-3