Internal And Auxiliary Supply Voltage Test - Lincoln Electric INVERTEC POWER WAVE 450 SVM112-B Service Manual

F-97

INTERNAL AND AUXILIARY SUPPLY VOLTAGE TEST

Service and repair should be performed by only Lincoln Electric factory trained personnel.
Unauthorized repairs performed on this equipment may result in danger to the technician or
machine operator and will invalidate your factory warranty. For your safety and to avoid elec-
trical shock, please observe all safety notes and precautions detailed throughout this manual.
If for any reason you do not understand the test procedures or are unable to perform the
test/repairs safely, contact the Lincoln Electric Service Department for electrical trou-
bleshooting assistance before you proceed. Call 1-800-833-9353 (WELD).
TEST DESCRIPTION
This test will determine if the proper voltages are present at the protection board, the
power board, the control board, and the display board.
MATERIALS NEEDED
Volt/Ohmmeter (Multimeter)
5/16" Nut driver
3/8" Nut driver
Internal Auxiliary Supply Wiring Diagram – Figure F.34
TROUBLESHOOTING & REPAIR
WARNING
This procedure takes approximately 45 minutes to perform.
POWER WAVE 450
F-97