Adjusting The Front Wheel Static Balance - Yamaha 2007 FZ6-NA Service Manual

A. FZ6-NA/FZ6-SA
B. FZ6-NAHG/FZ6-SAHG
3. Check:
• Front wheel sensor installation
Check if the wheel sensor housing is
installed properly.
Refer to "[D-3] MAINTENANCE OF THE
FRONT WHEEL SENSOR AND SENSOR
ROTOR" on page 4-11.
EAS21970
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
NOTE:
• After replacing the tire, wheel or both, the
front wheel static balance should be
adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
NOTE:
Place the front wheel on a suitable balancing
stand.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Spin the front wheel.
b. When the front wheel stops, put an "X
mark at the bottom of the wheel.
c. Turn the front wheel 90° so that the "X
mark is positioned as shown.
d. Release the front wheel.
e. When the wheel stops, put an "X
the bottom of the wheel.
f. Repeat steps (d) through (f) several times
until all the marks come to rest at the same
spot.
g. The spot where all the marks come to rest
is the front wheel's heavy spot "X".
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Adjust:
• Front wheel static balance
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install a balancing weight "1" onto the rim
exactly opposite the heavy spot "X".
NOTE:
Start with the lightest weight.
b. Turn the front wheel 90° so that the heavy
"
1
spot is positioned as shown.
4-13
FRONT WHEEL
"
1
" mark at
2