Yamaha 2007 FZ6-NA Service Manual page 103

FZ6-N/FZ6-NHG(W)
1. Rear brake light switch lead
2. Neutral switch lead
3. Fuel tank breather hose
4. Crankshaft position sensor lead
5. Throttle cables
6. Meter and left handlebar switch lead
7. Right handlebar switch lead
8. Wire harness
9. O sensor lead
2
10.Bracket
11.Fuel tank drain hose
12.Rear brake reservoir hose
13.Left handlebar switch lead
A. Pass the fuel tank breather hose, fuel tank
drain hose and brake light switch lead
through the guide of the stay assembly 2.
B. Clamp the tail/brake light switch lead
together with the O
neutral switch lead.
C. To the starter motor
D. Install the right handlebar switch lead cou-
pler through the hole of the bracket 2 from
the downside.
E. Route the starter motor lead by the inner
side of the air cut-off valve hose.
F. Pass the ignition coil leads #1 and #4
through inner side of the air cut-off valve
hose, and then between the frame and
bracket 2.
G. Pass the throttle cable through the hole
located on the right side of the frame.
Route the throttle cable above the wire har-
ness.
H. To the sub-wire harness
I. Pass the right handlebar switch lead
through the hole on the right side of the
frame. Route it under the inside of the
throttle cable and wire harness.
J. Route the right handlebar switch lead
under the bracket 2.
K. Route the coolant reservoir tank hose
under the cover 2. Route the radiator hose
(outside) outside.
L. Route the radiator hoses (2 pieces) under
the cover 2.
M. Route the crankshaft position sensor lead
inner side of the radiator hose.
N. Pull down the mark-painted sections of the
fuel tank breather hose and fuel tank drain
hose to be lower than the clamp position of
the muffler stay. Any order to take out the
fuel tank breather hose and fuel tank drain
hose can be accepted.
O. 0-20 mm (0-0.79 in)
P. Route the O sensor lead by the outer side
2
of the vehicle as viewed from the rear tail/
brake light switch lead.
sensor lead and the
2
Q. Clamping position should be at the center
of bend-R as shown in the illustration for
the rear brake reservoir tank hose.
R. Pass the fuel tank breather hose, fuel tank
drain hose and O
clamp and insert them to the bracket.
S. Clamp the O
of the vehicle.
T. Outside of the vehicle.
U. Attach the clamp so that the opening may
be turned to the outside of the vehicle.
V. To the sub-wire harness.
W. Pass the right handlebar switch lead
through the hole on the right side of the
frame. Route it under the inside of the
throttle cable and wire haress.
2-58
CABLE ROUTING
sensor lead through the
2
sensor lead to the front side
2