Starting Circuit Cut-Off System Operation - Yamaha 2007 FZ6-NA Service Manual

Table of Contents

STARTING CIRCUIT CUT-OFF SYSTEM OPERATION

If the engine stop switch is set to "

the starter motor can only operate if at least one of the following conditions is met:

• The transmission is in neutral (the neutral switch is closed).

• The clutch lever is pulled to the handlebar (the clutch switch is closed) and the sidestand is up (the

sidestand switch is closed).

The starting circuit cut-off relay prevents the starter motor from operating when neither of these con-

ditions has been met. In this instance, the starting circuit cut-off relay is open so current cannot

reach the starter motor. When at least one of the above conditions has been met the starting circuit

cut-off relay is closed and the engine can be started by pressing the starter switch.

a. WHEN THE TRANSMISSION IS IN NEU-

b. WHEN THE SIDESTAND IS UP AND THE

CLUTCH LEVER IS PULLED TO THE

2. Main fuse

3. Main switch

4. Ignition fuse

5. Engine stop switch

6. Starting circuit cut-off relay

8. Clutch switch

9. Sidestand switch

10.Neutral switch

11.Start switch

ELECTRIC STARTING SYSTEM

" and the main switch is set to "ON" (both switches are closed),

12.Starter relay

13.Starter motor

Table of Contents