Adjusting The Throttle Cable Free Play - Yamaha 2007 FZ6-NA Service Manual

▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Turn the idle adjusting screw "1" in direction
"a" or "b" until the specified engine idling
speed is obtained.
Direction "a"
Engine idling speed is increased.
Direction "b"
Engine idling speed is decreased.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4. Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE
CABLE FREE PLAY" on page 3-10.
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
EAS20630
ADJUSTING THE THROTTLE CABLE FREE
PLAY
NOTE:
Prior to adjusting the throttle cable free play,
the engine idling speed and throttle bodies
synchronization should be adjusted properly.
1. Check:
• Throttle cable free play "a"
Out of specification → Adjust.
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
2. Remove:
• Seat
Refer to "GENERAL CHASSIS" on page 4-
1.
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
• Air filter case
Refer to "GENERAL CHASSIS" on page 4-
1.
• Battery
Refer to "GENERAL CHASSIS" on page 4-
1 and "CHECKING AND CHARGING THE
BATTERY" on page 8-114.
3. Adjust:
• Throttle cable free play
NOTE:
When the throttle is opened, the accelerator
cable "1" is pulled.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
Throttle body side
a. Loosen the locknut "2" on the decelerator
cable.
b. Turn the adjusting nut "3" in direction "a" or
"b" to take up any slack on the decelerator
cable.
Direction "a"
Throttle cable free play is increased.
Direction "b"
Throttle cable free play is decreased.
c. Tighten the locknuts
NOTE:
If the specified throttle cable free play cannot
be obtained on the throttle body side of the
cable, use the adjusting nut on the handlebar
side.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
Handlebar side
a. Loosen the locknut "1".
3-10
ENGINE