Faema X2 GRANDITALIA User Manual page 34

English
!
4. Cleaning operations
STEAM TUBE (15) AND HOT WATER DISPENSER (14)
Wash with hot water and a clean cloth or sponge, removing
all organic matter.
Thoroughly rinse.
Clean up the inner part of the steam dispenser operating in
the following way:
direct the tube towards the cup tray, and paying particular
attention, allow the steam to flow at least once.
CUP TRAY (16)
At the end of the working day, pour a jug of hot water into the
tray (16) and remove any deposits from the drain. Remove
and wash under running water.
Do not use abrasive products, do not place in the dishwasher.
EXTERNAL PARTS
Clean with a soft cloth and products that DO NOT CONTAIN
ammonia or abrasives. Eliminate all organic residues from
the work area.
NOTE: do not spray cleaning liquids into the slots in the
panels.
COFFEE GROUND TRAY
Remove the coffee ground tray (17).
Empty it out and wash it under running water.
Thoroughly clean the zone where the tray (17) is housed
using a damp cloth. Remove any coffee grounds.
Fit the coffee ground tray back.
CAUTION
When the machine has not been used for
more than 8 hours, and in any case once a
!
day, the internal components must be washed
before use, in accordance to the following
instructions:
Coffee circuit
Keep the coffee circuit wash key (26) pressed for a few
seconds.
26 28
14
40
16
17
Hot water
Dispense hot water repeatedly (using the relative
command) until at least 2 liter of water have been
dispensed from the machine.
Steam
Allow the steam to flow through the nozzles for
approximately one minute, using the appropriate
commands.
Milk circuit: Remove the tube (40) from the milk container
and press the milk wash key (28).
N.B. Follow the instructions contained in this manual to
perform the various operations.
English
18
15
A