Punch Resist Loop Size Adjustment - Konica Minolta bizhub C451 Copy Operations

Utility mode
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The horizontal position of the punched holes is adjusted.
If no adjustment of the horizontal position of the punched holes was necessary in step 6, this completes
the procedure.
8
Use a Punch setting to print another sample copy.
9
Check the print result.
– Check that the horizontal position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.

Punch resist loop size adjustment

When printing with a Punch setting, the angle of punched holes along the side of the paper can be adjusted.
Note
For details on the Punch settings, refer to "Punching holes in copies ("Punch" settings)" on page 4-69.
The adjustment range differs depending on the finisher that is installed.
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Setting screen, refer to "Displaying the administrator
settings screen" on page 13-37.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
bizhub C451/C550/C650
13
13-57