Half-Fold Position - Konica Minolta bizhub C451 Copy Operations

13
– If the staple position is too far to the right of the center of
the paper, touch [-] to reduce the adjustment.
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The stapling position is adjusted.
If the stapling position was at the center of the paper in step 7, this completes the procedure.
9
Use the "Center Staple & Fold" setting to print another sample copy.
10
Check the print result.
– Check that the stapling position is adjusted to the center of the paper.
– If more adjustment is necessary, repeat steps 6 through 9.

Half-fold position

The folding position when printing with the "Half Fold" setting can be adjusted for each paper size and for
each paper type.
Note
[Half-Fold Position] appears only if optional finisher FS-608 is installed or if finisher FS-519 is installed
with the saddle stitcher attached.
The adjustment range differs depending on the finisher that is installed.
If the angle of the center folding position must be adjusted, contact your technical representative.
!
Detail
For details on the "Center Staple & Fold" setting, refer to "Binding copies at the center ("Center Staple
& Fold" setting)" on page 4-76.
0 Before making any adjustments, use the "Half-Fold" setting to print a single sample copy. Perform the
adjustment while checking the sample that was created.
13-50
Utility mode
bizhub C451/C550/C650