2N Helios IP Configuration Manual page 69

Door intercom

Hide thumbs Also See for Helios IP:

Table of Contents

Configuration

2.3

Associated switch

Set the switch to be activated by a valid card.

Plus card ID

Enter the ID of the plus card to be used for adding items into the list of valid cards

(RFID Card Reader - Installed Cards). If you leave this parameter blank, the

plus/minus card function cannot be applied.

Minus card ID

Enter the ID of the minus card to be used for removing items from the list of valid

cards (RFID Card Reader - Installed Cards). If you leave this parameter blank, the

plus/minus card function cannot be applied.

Wiegand Interface

If equipped with a RFID card reader, 2N

Helios IP offers the Wiegand interface

for connection of third party devices: an additional card reader, fingerprint reader

or access control/security system, for example.

Interface mode

Set the information transmission direction for the Wiegand interface of the

internal card reader. In the Input mode, 2N

Helios IP receives data sent along

the bus and compares them with the internal database of card identifiers. This

mode is used, e.g., for a biometric data reader. In the Output mode,

Helios IP sends identifiers of the read cards to the interface. This mode is

used, e.g., for connection of an access control system.

Change facility code

Enable a mode in which the facility code in the card identifier sent by the Wiegand

interface will be replaced with the code specified in the Facility code parameter.

Facility code

Facility code. Refer to the Change facility code parameter above.

Table of Contents

Helios ip