2N Helios IP Configuration Manual page 65

Quick dialling using digits
Enable user calling from the telephone directory by dialling the user number (two
or three digits) and confirmation with *.
Floor & Apartment dialling
Enable special calling to numbers included in the telephone directory by entering a
floor number on the numerical keypad and pushing a quick dialling button.
Buttons 1 – 6 represent apartments on the floor (A through F). The following
floors and apartments are assigned to telephone directory positions: 01A – 1, 01B
– 2, 01C – 3, 01D – 4, 01E – 5, 01F – 6, 02A – 7, 02B – 8 etc. until 99F – 594.
Keystroke timeout
Set the delay between two digits when entering a code or telephone number using
®
the 2N Helios IP keypad.
Enable telephone mode
Enable to set up calls directly to the telephone numbers entered from the
®
2N Helios IP numeric keypad using the *telephone_number* key sequence.
Dial digits limit
Define the maximum number of digits of a telephone number in the Telephone
mode. When the defined count is reached, the telephone number is dialled
automatically without the need to push * subsequently.
Legacy switch code
Set whether the first code in the switch 1 and switch 2 list may be entered from a
VoIP phone valid without an * confirmation.
Other Settings
Backlight level
Set the level of the keypad backlight.
Red LED control
Set the card reader input that activates the red LED located under the
®
2N Helios IP Vario name plates. The red LED can indicate the secured /
unsecured state, for example. This function is available in 2N
models without display, Part. Nos. 91371...U.
DHCP on/off by buttons
Set whether a quick dialling button combination may switch to obtaining the IP
address from the DHCP server upon the 2N
Device configuration subsection of 2N
Enable switch control by HTTP
Enable switch control by HTTP requests sent by 2N
change over upon the following HTTP (GET) request:
http://helios_ip_address/enu/lockstate.xml.p?lockXstate=Y, where X is the switch
number (1-4) and Y is 0 for switch off, 1 for switch on and 2 for change over.
Configuration
®
Helios IP restart as described in the
®
Helios IP Installation Manual.
®
Helios IP. Select ON, OFF or
2.3
®
Helios IP Vario
65