2N Helios IP Configuration Manual page 28

External Command
Switch-on command
Set the command to be sent to an external device (WEB relay, e.g.) via the HTTP
protocol (GET request) whenever the switch is activated. The required format is
http://ip_address/path. Example: http://192.168.1.50/relay1=on.
Switch-off command
Set the command to be sent to an external device (WEB relay, e.g.) via the HTTP
protocol (GET request) whenever the switch is deactivated. The required format is
http://ip_address/path. Example: http://192.168.1.50/relay1=off.
Switch Codes
A list of the universal switch codes to be entered using a telephone set or the
®
2N Helios IP keypad. The count of universal switch codes is determined by the
®
2N Helios IP model type; refer to the Model and licence overview subsection.
Access
Disable code entering from the user numeric keypad or telephone set.
Time profile
Assign a time profile to the switch code for validity management. Refer to the
Profiles subsection for details on time profile settings.
Switch Code Options
Enable ON/OFF mode
You are recommended to enable different activation/deactivation codes while
setting the bi-stable switch mode. Use this parameter to set a mode where odd
codes (1, 3, 5, etc.) are used for switch activation and even codes (2, 4, 6, etc.)
for switch deactivation. If this mode is OFF (default setting), then you can use any
code to turn the switch into the opposite state (ON/OFF). This does not apply to
the mono-stable switch mode where the activation time is prolonged.
Configuration 2.3
28