Dishdrawer Diagnostics; Display/Download Mode; Optical Led Download/Fault Display; Clearing Fault Logs - Fisher & Paykel DD603 User Manual

DIAGNOSTICS

DishDrawer Diagnostics

Dishwasher Diagnostics can only be entered in Power Off mode, ie. when
there is no display on the LCD or the badge LED's are off. Diagnostics is
entered by holding the KEYLOCK and START/PAUSE buttons
simultaneously for 5 seconds. Ensure that KEYLOCK is pushed first.
There are currently four levels of diagnostics. To move to the next level push
POWER. To enter a level push START/PAUSE. Once a level has been
entered, pushing POWER will exit diagnostics completely. If no level is
entered, then the display will cycle through the four levels and exit after the
last. On entering diagnostic mode, the first level is the Display/Download
Mode.

Display/Download Mode

In this mode, all LED's and LCD segments (except keylock) are illuminated.

Optical LED Download/Fault Display

An optical data download is available here to download all EE data to a PC or Palm PC
via the lower tub-home sensor light pipe. Hold the reader pen over the lower tub-home
sensor light pipe and press START/PAUSE to initiate the download. A short beep
indicates the start and finish of download.
The last two faults are displayed on the LCD (secondary control panel LEDs for
integrated models) during the optical download. The Current Fault code is displayed first
followed by the Previous Fault Code. To read the Fault Code on the secondary display,
refer to page 7 on Fault Codes.

Clearing Fault Logs

To clear the Current Fault, press the KEYLOCK button until a beep is
sounded. This action moves the Current Fault into the Previous Fault while
clearing the Current Fault. To Clear the Previous Fault press KEYLOCK
once more until the beep is sounded.
Warning: Once a fault has been cleared, it is permanently removed from
memory and cannot be recovered.
Press POWER to advance to the next level.
8