Fault Codes - Fisher & Paykel DD603 User Manual

Fault Codes

The faults are displayed in the LCD as one of 5 F (fatal) faults or 1 U (user)
fault along with the symbol of a spanner. A fatal fault will usually require the
assistance of a qualified service person, while a U1 user fault indicates the
machine had failed to prime within a certain length of time usually because
the tap has not been turned on. For this reason at the same time a U1 comes
up in the display we also show the symbol of a tap. In the Integrated models,
an LCD is not available, and the presence of a fault is indicated by a Red
centre LED, with the fault number indicated on the touch switch panel with
Red LEDs.
Once a fault is repaired it can be cleared by pressing the POWER button. If
the fault is still present then it will not clear.
A fatal or user fault is accompanied by a continuous pulsating beep, which
can be turned off by pressing either the POWER, START/PAUSE, or KEY
LOCK button.
The last two faults are logged into EE memory.
The other U (user) faults have been removed. The old U2 fault, which was
the tub forced open during a cycle, has been removed completely. Instead, if
the tub is forced open, the product simply pauses as if someone had pressed
the start/pause button. The old U3 fault, which indicated a failure to drain, i.e.
water left in the tub, will not show up a fault and the DishDrawer will continue
through the cycle.
17