Fisher & Paykel DD603 User Manual page 13

The DishDrawer is now in the Show Off mode and cycles through all of the
LED & LCD segments while pulsing the LCD backlight on and off.
Pressing the POWER button now puts the DishDrawer into the Showroom
Wash mode. Before running this mode the tub should be filled with water until
it is just touching the underside of the spray arm. The Showroom Wash is
started by pushing the START/PAUSE button whereby the following cycle is
run:-
The lid is pulled down.
The wash motor starts and runs for 4 minutes.
The wash motor stops.
The lid is lifted.
The display counts down to zero throughout this cycle.
The DishDrawer turns off at the end of this cycle.
The DishDrawer is still in the Showroom wash mode however, and it can be
re-run by pushing POWER and then START/PAUSE. Once Show
Off/Showroom Wash mode has been initiated, the mains power must be
removed to exit out.
13