IB32 Motherboard User Manual /
Engineering Spec.
Chapter 2:
2.1 Memory Module (SO-DIMM) Installation
The IB32 Motherboard provides one 204-pin SO-DIMM slot, and it supports up
to 8GB DDR3L 1333/1600MHz. When installing the Memory device, please
follow the steps below:
Step.1. Firmly inserts the SO-DIMM at an angle into its slot. Align the
SO-DIMM on the slot such that the notch on the SO-DIMM matches the break
on the slot.
Step.2. Press downwards on SO-DIMM until the retaining clips at both ends
fully snap back in place and the SO-DIMM is properly seated.
Caution
!
cause permanent damage to the development board and the
SO-DIMM if the SO-DIMM is forced into the slot at the incorrect
orientation.
Installations
The SO-DIMM only fits in one correct orientation. It will
7