EGi DOMOS2 User Manual page 72

alarms
Your domotic central unit can manage different sensors for detecting fire, gas, flooding or intruders. To
configure it, do as follows:
FIRE ALARM
It allows the fire sensor to determine whether or not generate an alarm. To activate this service, do as follows:
1. Press the MENU key . FIRE will be displayed.
2. Activate or deactivate the service by pressing OK/+ (activated) or NO/– (deactivated).
3. When the service is activated, the corresponding indicator triangle is displayed
GAS ALARM
It allows the gas sensor to determine whether or not generate an alarm. To activate this service, do as follows:
1. Press the MENU key . GAS will be displayed.
2. Activate or deactivate the service by pressing OK/+ (activated) or NO/– (deactivated).
3. When the service is activated, the corresponding indicator triangle is displayed
FLOODING ALARM
It allows the flooding sensor to determine whether or not generate an alarm. To activate this service, do as follows:
1. Press the MENU key . FLOOD will be displayed.
2. Activate or deactivate the service by pressing OK/+ (activated) or NO/– (deactivated).
3. Cuando el servicio está activado, aparece el triángulo correspondiente en el display
FIRE
st
1
F I R E
S I
nd
2
www.egiaudio.com
auxiliary modules
40510
GAS FLOODING
st
1
G A S F L O O D
S I S I
nd
2
INTRUDER ALARM
It allows to configure the intruder sensors.
1. Press the MENU key
2. When pressing (OK/+), T. GO IN is displayed (available time to deactivate
the alarm system when entering your home).
3. To modify this parameter (from 1 to 3 minutes), use the (OK/+) or (NO/–) key.
4. Press the MENU key
time to deactivate the alarm system when leaving your home).
(1).
5. To modify this parameter (from 1 to 5 minutes), use the (OK/+) or (NO/–) key.
6. Press CANCEL to go back to the main menu.
I N T RU D E R
(2).
Intruder alarm activation:
When passing the proximity card over the sensor to activate the alarm, ALARM ON is
displayed and the central unit activates the countdown time programmed to leave home.
When this time is finished, ALARM SET is displayed on the domotic central unit display.
(3).
When the system detects presence, ALARM ACT is displayed and the central unit
activates the countdown time programmed to enter home.
If the countdown is over and nobody has passed the proximity card over the sensor,
st
1
an acoustic alarm is generated for 2 minutes through the whole installation. After
nd
2 this time, the acoustic alarm is deactivated but if the intruder alarm has a relay
assigned to it, the relay continues activated until it is manually deactivated.
72
. INTRUDER is displayed.
now, T. GO OUT will be displayed (available
st st
1 1
T G O I N T G O O U T
: 0 3 : 0 2
nd
2
nd
2
st
1
nd
2