EGi DOMOS2 User Manual page 41

40250, 40260
other functions
DO NOT DISTURB
This function mutes any communication from the bell, entry phone or intercom
in the zone where the control unit is. To configure this, please do as follows.
1. Press EXIT MENU key until PRIV appears.
2. Press (OFF/–) and (OK/+/ON) to select YES (activated) or NO (deactivated).
3. The PRIVATE mark appears on the display.
PRIV ys
nd
2
st
1
ALARM CLOCK FUNCTION
The control unit has an embedded alarm clock that will let you connect the
audio system at the given time or switch on a buzzer.
To configure this utility:
1. Press the MENU key 3 times, AUDIO > INTCOM > SURVEI > until
MISCEL is displayed.
2. Press (OK/+/ON).
3. Press MENU key several times until ADJSTM appears.
4. Press (OK/+/ON) for 2 seconds.
control unit
5.
6.
7.
8.
9.
If the alarm clock is active, and BUZZER is deactivated, the audio program will be connected by the alarm clock.
– m i s c e l
nd
2
To easily connect or disconnect the alarm clock:
1.
2.
3.
41
WAKE-UP appears on the display.
Press (OK/+/ON) again to configure the time. The hour blinks.
Adjust the time with (OK/+/ON) or (OFF/–). Press MENU key
Press now MENU key to reach the BUZZR menu.
Press (OFF/–) and (OK/+/ON) to select YES (activated) or NO (deactivated).
A DJ U ST M
nd
2
st
1
Press EXIT MENU key until WAKE appears.
Press (OFF/–) and (OK/+/ON) to select YES (activated) or NO (deactivated).
The ALARM CLOCK mark appears on the display.
nd
2
st
1
to configure the minutes the same way.
WA K E - U P
nd nd nd st
2 2 2 1
st st
1 1
WAKEYS
nd
2
M 0 8 : 31
st
1
nd
2