Reset Factory Settings
All operating parameters are stored in nonvolatile memory resident in the
Imager, where they are permanently retained in the event of a power interruption.
When you receive your Imager, certain operating parameters have already been
set. These are the factory defaults, indicated by the symbol " " on the
programming menu pages (beneath the default programming symbol). Default
charts begin on page 5-1.
Depending on your model, scan one of the following bar codes to set the imager
to the original factory settings, clearing any programming changes you may have
made.
HD
HD10
LR
Status Check
Read the Show Software Revision symbol to transmit the software revision level
to the host terminal. The software revision will be printed out as
"REV_SW:$ProjectRevision:1.xx$;REV_WA:31204734-xxx."
Read the Show Data Formats symbol to transmit the existing Data Format Editor
formats. One format per line will be printed out.
Show Software
Show Data Formats
Revision
2 - 2