Cable Pinouts - Hand Held Products IMAGETEAM 4400 User Manual

Cable Pinouts

RS-232 Output, external power (IT4400 and IT4700)
Decoded output data format is provided at the modular connector in the
Imager.Interface cables normally supplied with the Imager are terminated with a
10 pin modular plug (P1) and a 9 pin Type D connector (P3) that is compatible
with all Welch Allyn decoders and terminals. See chart below.
P1
Pin 1
10 Pin Modular Plug
P1 connects to the Imager.
1 NC
2 Ground
3 +5VDC
4 Ground
5 RXD
6 TXD
7 +5VDC
8 RTS
9 CTS
10 TRIG
SH
1. The HHLC mode is not available on an IT4700 with external trigger capability. Con-
tact the factory if you require HHLC capability for an IT4700.
Pin 10
9 Pin Type D Female
P3 connects to your terminal.
No Connection
Supply Ground
Power Connection
Supply Ground
Receive Data - Serial Data to Imager
Transmit Data - Serial Data from Imager
Power Connection
Request to Send Data
Clear to Send Data
External Trigger (IT4700 only)
Drain Wire (Shield)
P2
P3
1
Power Pig Tail
P2 connects to
the external
power supply.
Inner Outer
View B-B
5 1
9
6
View A-A
P2
Inner
|
Outer
0
5
Red
3 Black
Green
2
8
Blue
7
Brown
SH
9 - 3