Autotrigger; Scan Stand; Scan Stand Led Intensity - Hand Held Products IMAGETEAM 4400 User Manual

AutoTrigger

Two AutoTrigger Modes are available: Scan Stand and Presentation Mode.
When a unit is in Scan Stand mode, the LED shines at the symbol on the base
of the stand which tells it to remain idle. When a different code is presented, the
Imager is triggered to read the new code.
Presentation mode is for those applications where a scan stand will not work, i.e.,
when large packages must be scanned. To program the device for presentation
mode, refer to "Presentation Mode" on page 2-21.

Scan Stand

This selection programs the Imager to work in a Scan Stand.
* Off On

Scan Stand LED Intensity

This sets the idle LED intensity when the Imager is in Scan Stand mode. When
a unit is in Scan Stand mode, the LED shines at the symbol on the base of the
stand which tells it to remain idle. When a different code is presented, the Imager
is triggered to read the new code. If the Imager has difficulty going back to
reading the Scan Stand's fixed code, for instance, in a low lighting situation, you
may want to adjust the Scan Stand LED Intensity. A two digit number between
15 and 75 must be input after the Scan Stand LED Intensity programming code
is scanned. A 15 corresponds to the lowest intensity level, and a 75 corresponds
to the highest intensity level. 15 is the default setting.
Note that when the unit is triggered to read a code, the unit uses the LED power
level specified through "LED Power Level" on page 2-17.
Set Scan Stand LED Intensity
2 - 20