Troubleshooting
The Imager automatically performs self-tests whenever you turn it on. If your
Imager is not functioning properly, review the following Troubleshooting Guide to
try to isolate the problem.
Troubleshooting Guide
Is the power on? Are the illumination LEDs on?
If the illumination LEDs in the Imager aren't illuminated, check that:
1. The cable is connected properly.
2. The host system power is on (if external power isn't used).
Is the Imager having trouble reading your symbols?
If the Imager isn't reading symbols well, check that the symbols:
1. Aren't smeared, rough, scratched, or exhibiting voids.
2. Aren't coated with frost or water droplets on the surface.
3. Are enabled in the Imager or in the decoder the Imager connects to.
10 - 4