Reset Factory Settings; Status Check; All Symbologies - Hand Held Products 4410, 4710 User Manual

Reset Factory Settings

All operating parameters are stored in nonvolatile memory resident in the
Imager, where they are permanently retained in the event of a power interruption.
When you receive your Imager, certain operating parameters have already been
set. These are the factory defaults, indicated by the symbol "✱" on the
programming menu pages (beneath the default programming symbol). Default
charts begin on page 5-1.
Default

Status Check

Read the Show Software Revision symbol to transmit the software revision
level to the host terminal. The software revision will be printed out as
"REV_SW:$ProjectRevision:1.xx$;REV_WA:31204960-xxx."
Read the Show Data Formats symbol to transmit the existing Data Format
Editor formats. One format per line will be printed out.
Show Data Formats
Show Software
Revision

All Symbologies

If you want to decode all the symbologies allowable for your scanner, scan the
All Symbologies On code.
All Symbologies All Symbologies
On Off
2 - 2 IMAGETEAM™ 4410/4710 User's Guide